Sienna FWD V6-3.3L (3MZ-FE) (2006)
i.
Align the groove of the manual valve with the pin of the lever.
j.
Install the 17 bolts.
Torque: 11 Nm (110 kg-cm, 8 ft. lbs.)
NOTICE:
^
Push the valve body against the accumulator piston springs and check ball body to install the valve body.
^
First, temporarily tighten the bolts marked with
(1) in the illustration because they are positioning bolts.
Bolt length:
Bolt A: 41 mm (1.614 inch)
Bolt B: 57 mm (2.244 inch)
Bolt C: 25 mm (0.984 inch)
2. INSTALL VALVE BODY OIL STRAINER ASSEMBLY
a. Coat a new O-ring with ATF.
b. Install the O-ring to the oil strainer.
c. Install the oil strainer with the 3 bolts.
Torque: 11 Nm (110 kg-cm, 8 ft. lbs.)
3. INSTALL TRANSMISSION WIRE
a. Coat the O-ring with ATF.
b. Install the ATF temperature sensor with the lock plate and bolt.
Torque: 6.6 Nm (67 kg-cm, 58 inch lbs.)
c. Connect the 7 shift solenoid valve connectors.