Sienna FWD V6-3.3L (3MZ-FE) (2006)
7. SEPARATE TIE ROD END SUB-ASSEMBLY LH
a. Remove the cotter pin and nut.
8. SEPARATE NO.1 FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER
a. Remove the bolt and 2 nuts, and separate the No.1 front suspension arm sub-assembly lower from the lower ball joint.
9. SEPARATE FRONT AXLE ASSEMBLY LH
a. Using a plastic hammer, separate the drive shaft from the axle hub.
NOTICE: Be careful not to damage the boot and speed sensor rotor.
10. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
a. Using SST remove the front drive shaft assembly LH.
SST 09520-01010, 09520-24010 (09520-32040)
NOTICE:
^
Be careful not to damage the transaxle case oil seal, inboard joint boot and drive shaft dust cover.
^
Be careful not to drop the drive shaft assembly.