Sienna FWD V6-3.3L (3MZ-FE) (2006)
a. Using SST and a press, install a new drive shaft dust cover RH until the distance from the tip of the center drive shaft to the drive shaft dust
cover RH meets the specification, as shown in the illustration.
SST 09527-10011
Distance: 109.5 mm (4.311 inch)
NOTICE:
^
Dust cover should be completely installed.
^
Be careful not to damage the dust cover.
5. INSTALL FRONT DRIVE SHAFT DUST COVER RH (for 4WD)
a. Using SST and a press, install a new drive shaft dust cover RH.
SST 09527-10011
NOTICE:
^
Dust cover should be completely installed.
^
Be careful not to damage the dust cover.
6. INSTALL FRONT DRIVE SHAFT DUST COVER LH
a. Using SST and a press, install a new drive shaft dust cover LH.
SST 09527-10011
NOTICE:
^
Dust cover should be completely installed.
^
Be careful not to damage the dust cover.
7. INSTALL FRONT DRIVE INNER SHAFT INNER LH SHAFT SNAP RING
a. Install a new hole snap ring.
8. INSTALL FRONT DRIVE INNER SHAFT INNER RH SHAFT SNAP RING (for 4WD)
a. Install a new hole snap ring.
9. INSTALL OUTBOARD JOINT BOOT
HINT: Before installing the boots, wrap the spline of the drive shaft with vinyl tape to prevent the boots from being damaged.