Sienna FWD V6-3.3L (3MZ-FE) (2006)
h. Align the matchmarks, install the inboard joint assembly to the outboard joint shaft assembly.
15. INSTALL INBOARD JOINT BOOT
a. Install the inboard joint boot to the inboard joint assembly.
16. INSTALL FRONT AXLE INBOARD JOINT BOOT LH CLAMP
a. Hold the outboard joint shaft assembly between aluminum plates in a vise.
NOTICE: Do not overtighten the vise.
b. Install the inboard joint boot No.2 clamp onto the boot.
c. Place SST onto the inboard joint boot No.2 clamp.
SST 09521-24010
d. Tighten the SST so that the inboard joint boot No.2 clamp is pinched.
SST 09521-24010
NOTICE: Do not overtighten the SST.
e. Using SST, measure the clearance of the inboard joint boot No.2 clamp.
SST 09240-00020
Clearance: 0.8 mm (0.031 inch) or less
NOTICE: When the measured value is greater than the specified value, retighten the clamp.
17. INSTALL INBOARD JOINT BOOT CLAMP
a. Install the outboard joint boot clamp perform the same procedures as for the inboard joint boot No.2 clamp.