Sienna FWD V6-3.3L (3MZ-FE) (2006)
4. INSTALL FRONT AXLE ASSEMBLY LH
a. Install the drive shaft assembly LH to the front axle assembly LH.
NOTICE:
^
Be careful not to damage the outboard joint boot.
^
Be careful not to damage the speed sensor rotor.
5. INSTALL NO.1 FRONT SUSPENSION ARM SUB ASSEMBLY LOWER LH
a. Install the lower ball joint to the front suspension arm sub-assembly lower with the bolt and nuts.
Torque: 127 Nm (1,300 kg-cm, 94 ft. lbs.)
6. INSTALL TIE ROD END SUB-ASSEMBLY LH
a. Install the tie rod end to the steering knuckle with the nut.
Torque: 49 Nm (500 kg-cm, 36 ft. lbs.)
b. Install a new cotter pin.
NOTICE: If the holes for the cotter pin are not are not aligned, tighten the nut up to 60° further.
7. INSTALL SPEED SENSOR FRONT LH
a. Install the speed sensor to the steering knuckle with the bolt.
Torque: 8.0 Nm (82 kg-cm, 71 inch lbs.)
NOTICE: Prevent foreign matter from adhering to the speed sensor.