Sienna FWD V6-3.3L (3MZ-FE) (2006)
8. REMOVE FRONT AXLE ASSEMBLY LH
a. Using a plastic hammer, separate the front drive shaft assembly LH from the front axle hub sub assembly LH.
NOTICE: Be careful not to damage the boot and ABS speed sensor rotor.
b. Remove the 2 bolts, nuts and steering knuckle LH with the front axle nub sub-assembly LH.
DISASSEMBLY
1. REMOVE LOWER BALL JOINT ASSEMBLY FRONT LH
a. Remove the cotter pin and nut.
b. Using SST(s), remove the lower ball joint assembly front LH.
SST 09628-62011
2. REMOVE FRONT WHEEL BEARING DUST DEFLECTOR NO.1 LH
a. Using a screwdriver, remove the bearing dust deflector NO.1 LH.