Sienna FWD V6-3.3L (3MZ-FE) (2006)
3. Remove rear door trim board sub-assembly.
A. Remove the screw.
B. Using the plastic pry tool disengage the 9 clips and remove the trim board.
NOTE
In order to prevent the door panel from being damaged, cover the areas with protective tape as indicated by arrow marks in the illustration.
4. Remove and replace the window regulator bolts from the regulator and replace with the NEW parts.
Remove/replace bolts one at a time and then torque each bolt.
Torque: 7 N*m (71 kgf*cm, 62 in*lbf)
5. Assemble the door panel and components in the reverse order of disassembly.
Technical Service Bulletin # SB0286-10
Date: 101013
Body - Front/Side Door Windows Rattling Or Inoperative
T-SB-0286-10
October 13, 2010
Window Rattle Noise
Service Category
Vehicle Exterior
Section
Window/Glass
Market
USA
Applicability
Introduction