Sienna FWD V6-3.5L (2GR-FE) (2009)
Tire Pressure Monitor Receiver / Transponder: Service and Repair
Installation
TIRE AND WHEEL: TIRE PRESSURE WARNING RECEIVER (w/ Antenna): INSTALLATION
INSTALLATION
1. INSTALL TIRE PRESSURE WARNING RECEIVER ASSEMBLY
(a) Connect the connector.
(b) Install the tire pressure warning receiver assembly with the bolt.
Torque: 5.0 Nm (51 kgf-cm, 44in-lbf)
2. INSTALL ROOF HEADLINING ASSEMBLY
HINT: Refer to the instructions for INSTALLATION of the ROOF HEADLINING See: Body and Frame/Interior Moulding /
Trim/Headliner/Service and Repair/Installation.
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. INSPECT TIRE PRESSURE WARNING SYSTEM
HINT: See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring System/Testing and Inspection/Initial Inspection and
Diagnostic Overview/Test Mode Procedure.