Parking Brake Shoe Testing and Inspection - Solara L4-24L (2AZ-FE) (2006)
![background image](/toyota/solara/l4-2.4l_(2az-fe)/Page-873004.png)
If the clearance is not within the specification, replace the shim with one of the correct size.
c. Apply high temperature grease to the adjusting bolt.
d. Install the shoe adjusting screw set and tension spring to the front and rear shoe.
e. Install the 2 pins, 4 cups and 2 shoe hold-down springs.
f.
Connect the parking brake cable No.3 to the shoe lever.
g. Install the front and rear parking brake shoe.
3. INSTALL PARKING BRAKE SHOE STRUT LH
a. Attach the parking brake shoe strut LH and the parking brake shoe strut compression spring to the parking brake shoe assembly LH No.2 and
parking brake shoe assembly LH No. 1.
4. INSTALL PARKING BRAKE SHOE RETURN TENSION SPRING
a. Using needle-nose pliers, install the 2 return tension springs No. 1.
HINT: First install the front side spring then the rear side spring.
5. CHECK PARKING BRAKE INSTALLATION
a. Check that each part is installed properly.