Solara L4-2.4L (2AZ-FE) (2006)
1
Raise the ratchet pawl, fully push in the plunger and apply the hook to the pin so that the plunger cannot spring out.
2
Install a new gasket and the chain tensioner with the 2 nuts.
Torque: 9.0 Nm (92 kgf-cm, 80 inch lbs.)
NOTICE: When installing the tensioner, set the hook again if the hook releases the plunger.
3
Turn the crankshaft counterclockwise, and disconnect the plunger knock pin from the hook.
4
Turn the crankshaft clockwise, and check that the chain tensioner slipper is pushed by the plunger.