Solara L4-2.4L (2AZ-FE) (2006)
Seat Belt: Removal and Replacement
Front Seat Outer Belt Assembly
REMOVAL
HINT:
-
The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information
are included.
-
Use the same procedures for the RH side and LH side.
-
A bolt without a torque specification is shown in the standard bolt chart.
1. REMOVE REAR SEAT CUSHION ASSEMBLY
2. REMOVE REAR SEATBACK ASSEMBLY LH
3. REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY LH
4. REMOVE FRONT DOOR SCUFF PLATE LH
5. REMOVE QUARTER TRIM PANEL ASSEMBLY FRONT LH
6. REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH
CAUTION:
-
Removal of the seat belt pretensioner must be started at least 90 seconds after the ignition switch is turned OFF and the negative (-) terminal
cable is disconnected from the battery.
-
Carefully read the notes for the "pretensioner" in the SRS airbag system section and the front seat outer belt section.
a. Disconnect the pretensioner connector, as shown in the illustration.
b. Remove the seat belt cover.
c. Remove the 4 bolts and outer belt.
INSTALLATION
1. INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH
NOTE: Do not disassemble the retractor.