Solara L4-2.4L (2AZ-FE) (2006)
d. Check the ELR lock.
NOTE: The check should be performed with the outer belt assembly installed.
1. With the belt installed, check that the belt locks when it is pulled out quickly.
If operation is not as specified, replace the belt assembly.
e. Check the fastening function of the child restraint system.
NOTE: The check should be performed with the outer belt assembly installed.
1. When the belt is pulled out fully, the belt should automatically try to retract.
2. After the belt has fully retracted, the belt should be able to be pulled out and retracted again.
If operation is not as specified, replace the belt assembly.
2. INSTALL REAR SEAT OUTER BELT ASSEMBLY LH
NOTE: Do not disassemble the retractor.
a. Check the degree of tilt when the belt begins to lock the ELR.
b. Check the amount of inclination required to lock the retractor.
1. When the inclination of the retractor is 15 degrees or less, check that the belt can be pulled from the retractor. When the inclination of the
retractor is over 45 degrees, check that the belt locks.
If operation is not as specified, replace the belt assembly.
c. Install the inner belt with the 2 bolts.
Torque: 42 N.m (430 kgf.cm, 31 in.lbf)
NOTE: Do not make the anchor part run onto the protruding part of the floor panel.
d. Check the ELR lock
NOTE: The check should be performed with the outer belt assembly installed.
1. With the belt installed, check that the belt locks when it is pulled out quickly.
If operation is not as specified, replace the belt assembly.
e. Check fastening function of the child restraint system.
NOTE: The check should be performed with the outer belt assembly installed.