Solara L4-2.4L (2AZ-FE) (2006)
2. INSPECT AND ADJUST PEDAL FREE PLAY AND PUSH ROD PLAY
a. Check that pedal free play and push rod play are correct.
1
Depress the pedal until clutch resistance begins to be felt.
Pedal free play: 5.0 to 15.0 mm (0.197 to 0.591 inch)
2
Gently depress the pedal the resistance begins to increase a little.
Push rod play at pedal top: 1.0 to 5.0 mm (0.039 to 0.197 inch)
b. Adjust the pedal free play and push rod play
1
Remove the instrument panel finish panel subassembly lower and instrument panel insert sub-assembly lower LH.
2
Loosen the lock nut and turn the push rod until correct free play and push rod play are obtained.
3
Tighten the lock nut.
Torque: 12 Nm (120 kgf-cm, 9 ft. lbs.)
4
After adjusting the pedal free play, check the pedal height.
5
Install the instrument panel insert subassembly lower LH and instrument panel finish panel sub-assembly lower.
3. INSPECT CLUTCH RELEASE POINT
a. Check the clutch release point.
1
Pull the parking brake lever and install a wheel stopper.
2
Start the engine and run of idle.
3
Without depressing the clutch pedal, slowly more the shift lever into reverse until the gears contact.
4
Gradually depress the clutch pedal and measure the stroke distance from the point that the gear noise stops (release point) up to the full
stroke end position.
Standard distance: 25 mm (0.98 inch) or more (From pedal stroke end position to release point)
If the distance is not as specified, perform the following operations.
^ Check pedal height.
^ Check push rod play and pedal free play.
^ Bleed the clutch line.
^ Check the clutch cover assembly and disc assembly.
INSTALLATION
1. INSTALL CLUTCH MASTER CYLINDER PUSH ROD CLEVIS BUSH
a. Apply MP grease to the inside of a new bush.
b. Install the clevis bush to the clutch pedal sub assembly.