Solara V6-3.3L (3MZ-FE) (2004)
b. Connect the hand-held tester to the DLC3.
c. Turn the ignition switch to the ON position.
d. Operate the hand-held tester to test mode (SIGNAL CHECK).
e. Obtain the zero point of the yaw rate sensor and deceleration sensor:
1. Keep the vehicle in the stationary condition on a level surface for 2 seconds. or more.
2. Check that the VSC warning light blinks.
HINT:
- If the VSC warning light does not blink, perform the zero point calibration again.
- The zero point calibration is performed only once after the system enters the test mode.
- Calibration cannot be performed again until the stored data is cleared once.
f.
Turn the ignition switch off.