Solara Coupe L4-2.4L (2AZ-FE) (2007)
Sunroof / Moonroof Module: Technical Service Bulletins
Body - Moonroof Initialization Procedure
PRE-DELIVERY SERVICE
PD029-06
Title:
INITIALIZATION OF MOON ROOF
DURING PDS
Models:
'07 Solara
May 24, 2006
Introduction
The moon roof on 2007 model year Solara vehicles must be initialized after installing the DCC fuse during Pre-Delivery Service (PDS).
The installation of the DCC fuse, and the initialization procedure shown below, will enable the operation of the "one-touch slide open and close"
"one-touch tilt up and down," and "jam protection" functions of the sliding roof.
NOTE:
Any time the battery terminal has been disconnected, the moon roof must be re-initialized.
Applicable Vehicles
^
2007 model year Solara vehicles.
Initialization Procedure
1.
Turn the ignition switch to the ~ON" position.
2.
Push and hold the moon roof switch to the "TILT UP" side until the moon roof tilts all the way up and then tilts down slightly (approximately 10
mm [0.4 in.]) at the rear.
3.
Check for proper operation of the "one-touch slide open and close" and "one-touch tilt up and down" functions by pushing the switch briefly to the
"SLIDE OPEN" and "TILT UP" positions.
NOTE:
Jam protection function becomes effective through the above initialization procedure.