Solara Coupe L4-2.4L (2AZ-FE) (2007)
Throttle Body: Service and Repair
REMOVAL
1. DRAIN ENGINE COOLANT
2. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
3. REMOVE THROTTLE BODY ASSEMBLY
a. Disconnect the throttle control motor & throttle position sensor connector.
b. Disconnect the vacuum hose from the throttle body.
c. Disconnect the 2 water by-pass hoses.
d. Remove the 4 bolts, fuel pipe support and throttle body.
e. Remove the gasket.
INSTALLATION
1. INSTALL THROTTLE BODY ASSEMBLY
a. Install a new gasket on the intake manifold, as shown in the illustration.
b. Install the throttle body and fuel pipe support with the 4 bolts.
Torque: 30 N.m (305 kgf.cm, 22 ft.lbf)
c. Connect the 2 water by-pass hoses to the throttle body.
d. Connect the throttle control motor & throttle position sensor connector.
e. Connect the vacuum hose to the throttle body
2. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE
3. ADD ENGINE COOLANT