Solara Coupe L4-2.4L (2AZ-FE) (2007)
(e)
After the tire is inflated, the valve nut may be loose. Retighten the nut to the specified torque and then check for air leaks with soapy water.
Torque: 4.0 Nm (41 kgf-cm, 35 inch lbs.)
NOTICE: No further tightening is required once the nut is tightened to the specified torque.
2. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
3. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
4. INSTALL GRAND SPARE TIRE (w/ Grand Spare Tire)
5. INSPECT TIRE
6. REGISTER TRANSMITTER ID
7. INSPECT TIRE PRESSURE WARNING SYSTEM
DISPOSAL
HINT: The tire pressure warning valve subassembly is powered by a lithium battery. When disposing of the tire pressure warning valve subassembly,
remove the battery and dispose of it correctly.
1. DISPOSE OF TIRE PRESSURE WARNING VALVE SUBASSEMBLY
(a)
Use the tip of a screwdriver to pry off the back cover.
(b) The battery and base board covered with resin are exposed. While taking out the battery, cut the 2 terminals that connect the battery to the
base board.
HINT: The battery and base board are covered with silicon.