Solara Coupe L4-2.4L (2AZ-FE) (2007)
d. Using a vernier caliper, measure the commutator's length.
Standard length: 3.1 to 3.8 mm (0.122 to 0.150 in.)
If the length is greater than the maximum, replace the starter armature assembly.
4. INSPECT STARTER COMMUTATOR END FRAME ASSEMBLY
a. Using a vernier caliper, measure the brush length.
Specified length: 4.0 to 9.0 mm (0.158 to 0.359 in.)
If the length is less than the minimum, replace the end frame assembly.
b. Check the brush insulation.
1. Measure the resistance between the positive (+) and negative (-) brush.
Standard: 10 kohms or higher
If the result is not as specified, repair or replace the end frame assembly.
5. INSPECT CLUTCH & BEARING CENTER