Solara Coupe L4-2.4L (2AZ-FE) (2007)
11. INSTALL STEERING RACK END SUBASSEMBLY
(a)
Install 2 new claw washers, and temporarily install the LH and the RH steering rack end subassembly.
HINT: Align the claws of the claw washer with the steering rack grooves.
(b) Using SST, install the 2 steering rack end subassemblies.
SST 09922-10010
Torque: 60 Nm (615 kgf-cm, 45 ft. lbs.)
NOTICE:
^
Use SST 09922-10010 following the direction shown in the illustration.
^
Use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
HINT: Using SST, hold the rack and install the steering rack end subassembly.
(c)
Using a brass bar and a hammer, stake the 2 claw washers.
NOTICE: Avoid any impact to the steering rack.
12. INSTALL STEERING RACK BOOT NO.2
(a)
Apply silicon grease to the inside of the small opening of the rack boot No.2.
(b) Install the rack boot No.2 to the groove on the rack housing.
NOTICE: Be careful not to damage or twist the boot.
13. INSTALL STEERING RACK BOOT NO.1