Solara Coupe V6-3.3L (3MZ-FE) (2008)
REMOVAL
1. DRAIN BRAKE FLUID
NOTE: Wash brake fluid off immediately if it adheres to any painted surface.
2. DISCONNECT BATTERY NEGATIVE TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. (See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization)
3. REMOVE BRAKE ACTUATOR WITH BRACKET
(a) Release the latch of the brake actuator connector to disconnect the connector.
(b) Using SST, disconnect the 6 brake tubes from the brake actuator.
(c) Use tags or make a memo to identify the reconnection points.
(d) Remove the 3 bolts and brake actuator with bracket.
NOTE: Be careful not to damage the brake tubes and wire harness.
4. REMOVE BRAKE ACTUATOR
(a) Remove the 2 nuts and brake actuator from the brake actuator bracket.
Installation
BRAKE CONTROL: BRAKE ACTUATOR:
INSTALLATION
1. INSTALL BRAKE ACTUATOR