Solara Coupe V6-3.3L (3MZ-FE) (2008)
REMOVAL
HINT: COMPONENTS: (See: Wheel Hub/Service and Repair/Front Axle Hub/Components)
-
Use the same procedures for the RH side and LH side.
-
The procedures listed below are for the LH side.
1. REMOVE FRONT WHEEL
2. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY LH
3. REMOVE FRONT DISC
4. REMOVE FRONT AXLE LH HUB BOLT
(a) Temporarily install the 2 nuts and 2 washers to the front axle LH hub bolt as shown in the illustration.
(b) Using SST and a screwdriver or an equivalent to hold the front axle, remove the front axle LH hub bolt.
SST: 09628-10011
Installation
AXLE: FRONT AXLE HUB BOLT:
INSTALLATION
1. INSTALL FRONT AXLE LH HUB BOLT
(a) Install a washer and nut to a new front axle LH hub bolt as shown in the illustration.
(b) Using a screwdriver to hold the front axle, install a new hub bolt by tightening the nut.
2. INSTALL FRONT DISC
3. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY LH
4. INSTALL FRONT WHEEL
Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)