Solara Coupe V6-3.3L (3MZ-FE) (2008)
Standard resistance:
(b) Measure the voltage according to the value(s) in the table below.
Standard voltage:
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE BRAKE ACTUATOR
Steering Angle Sensor Communication Stop Mode
CAN COMMUNICATION SYSTEM: Steering Angle Sensor Communication Stop Mode
Steering Angle Sensor Communication Stop Mode
DESCRIPTION
HINT: "Steering Angle Sensor" refers to the circuit that includes the steering angle sensor.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
-
Turn the ignition switch off before measuring the resistance of the CAN main wires and CAN branch wires.
-
After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not operating.
-
Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or
the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.
HINT: Operating the ignition switch, any other switches, or any doors triggers related ECU and sensor communication on the CAN. This
communication will cause the resistance value to change.
PROCEDURE