Solara Coupe V6-3.3L (3MZ-FE) (2008)
Seat Occupant Classification Module - Air Bag: Service and Repair
Installation
SUPPLEMENTAL RESTRAINT SYSTEM: OCCUPANT CLASSIFICATION ECU:
INSTALLATION
1. INSTALL OCCUPANT CLASSIFICATION ECU
(a) Check that the ignition switch is off.
(b) Check that the battery negative (-) terminal is disconnected.
CAUTION: After removing the terminal, wait for at least 90 seconds before starting the operation.
(c) Install the occupant classification ECU.
(d) Connect the connectors to the occupant classification ECU.
NOTICE:
-
If the occupant classification ECU has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace it
with a new one.
-
When installing the occupant classification ECU, be careful that the SRS wiring does not interfere with other parts and that it is not
pinched between other parts.
2. INSTALL FRONT RH SEAT ASSEMBLY
HINT: (See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front Seat Assembly (for Manual Seat)/Removal) power
seat, (See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front Seat Assembly (for Power Seat)/Removal) manual
seat.
3. CONNECT BATTERY NEGATIVE TERMINAL
NOTE: When disconnecting the negative (-) battery terminal, initialize the following systems after the terminal is reconnected.
4. OCCUPANT CLASSIFICATION ECU INITIALIZATION
HINT: (See: Restraint Systems/Testing and Inspection/Programming and Relearning)
5. INSPECT SRS WARNING LIGHT
HINT: (See: Restraint Systems/Air Bag Systems/Testing and Inspection/Symptom Related Diagnostic Procedures/Problem Symptoms Table)