Solara Coupe V6-3.3L (3MZ-FE) (2008)
(2) Place the outer belt on the ground and cover it with a tire with a wheel attached.
NOTE: Set up the front seat outer belt assembly as shown in the illustration.
(3) Move SST at least 10 m (33 ft) away from the wheel.
NOTE: Take care not to damage the SST wire harness.
(d) Activate the seat belt pretensioner.
(1) Connect SST red clip to the battery's positive (+) terminal and the black clip to the battery's negative (-) terminal.
(2) Check that no one is within 10 m (33 ft) of the wheel.
(3) Press SST activation switch to activate the seat belt pretensioner.
HINT: The seat belt pretensioner operates at the same time as the SST activation switch's LED light.
(e) Dispose of the outer belt (with the seat belt pretensioner).
CAUTION:
-
Do not touch the outer belt for at least 30 minutes after the seat belt pretensioner has been activated. It is very hot.
-
Use gloves and safety glasses when handling an outer belt assembly whose pretensioner that has been activated.
-
Always wash your hands with water after completing disposal.
-
Do not apply water to an outer belt assembly that has an activated pretensioner.
(1) Remove the tire with wheel and SST.
(2) Place the outer belt in a plastic bag, tie the end tightly and dispose of it in the same way as other general parts.