Solara Coupe V6-3.3L (3MZ-FE) (2008)
/Page-1512001.png)
Seat Position Sensor: Service and Repair
Installation
SUPPLEMENTAL RESTRAINT SYSTEM: SEAT POSITION SENSOR:
INSTALLATION
1. INSTALL SEAT POSITION AIRBAG SENSOR
(a) Check that the ignition switch is off.
(b) Check that the battery negative (-) terminal is disconnected.
CAUTION: After removing the terminal, wait for at least 90 seconds before starting the operation.
(c) Using a feeler gauge 1 mm (0.039 in.), install the seat position airbag sensor.
-
If the seat position airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace
the seat position airbag sensor with a new one.
-
When installing the seat position airbag sensor, be careful that the SRS wiring does not interfere with other parts and is not pinched
between other parts.
HINT: Be sure to maintain a clearance between the seat position airbag sensor and the seat rail is within 0.6 mm (0.023 in.) to 2 mm (0.079
in.).
(d) Using a torx socket wrench, tighten the torx screw to install the seat position airbag sensor.
Torque: 8.0 Nm (82 kgf-cm, 71 in-lbf)
(e) Make sure that a clearance between the seat position airbag sensor and the seat rail is within 0.6 mm (0.023 in.) to 2 mm (0.079 in.).
(f) Connect the connector to the seat position airbag sensor.
(g) Check that there is no looseness in the installation parts of the seat position airbag sensor.
2. INSTALL FRONT LH SEAT ASSEMBLY
HINT: (See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front Seat Assembly (for Power Seat)/Removal) Power
Seat, (See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front Seat Assembly (for Manual Seat)/Removal) Manual
Seat
3. CONNECT BATTERY NEGATIVE TERMINAL
NOTE: When disconnecting the negative (-) battery terminal, initialize the following systems after the terminal is reconnected.
4. INSPECT SRS WARNING LIGHT
HINT: (See: Air Bag Systems/Testing and Inspection/Symptom Related Diagnostic Procedures/Problem Symptoms Table)
