Solara Coupe V6-3.3L (3MZ-FE) (2008)
(c) 2AZ-FE:
Install the tube clamp with the nut.
Torque: 9.8 Nm (100 kgf-cm, 87 in-lbf)
(d) 3MZ-FE:
Install the tube clamp and the heat insulator with the nut.
Torque: 9.8 Nm (100 kgf-cm, 87 in-lbf)
(e) Install the tube clamp with the bolt.
Torque: 9.8 Nm (100 kgf-cm, 87 in-lbf)
4. INSTALL FRONT STABILIZER BRACKET NO.1 LH
(a) Install the stabilizer bar bush No.1 to the stabilizer bar.
(b) Install the front stabilizer bracket No.1 LH with the 2 bolts.
Torque: 27 Nm (275 kgf-cm, 20 ft-lbf)
5. INSTALL FRONT STABILIZER BRACKET NO.1 RH
HINT: Perform the same procedure as for the LH.
6. INSTALL FRONT STABILIZER LINK ASSEMBLY LH (See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Service and Repair/Installation)
7. INSTALL FRONT STABILIZER LINK ASSEMBLY RH
HINT: Perform the same procedure as for the LH.
8. INSTALL TIE ROD ASSEMBLY LH
(a) Install the tie rod assembly LH. (See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and
Repair/Installation)
9. INSTALL TIE ROD ASSEMBLY RH
HINT: Perform the same procedure as for the LH.
10. INSTALL FRONT WHEEL
Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)
11. INSTALL STEERING INTERMEDIATE SHAFT ASSEMBLY