Solara Coupe V6-3.3L (3MZ-FE) (2008)
/Page-1980006.png)
(a) Using a brush or sponge, apply Primer G to the contact surface of the windshield glass.
NOTICE:
-
Allow the Primer G to dry for 3 minutes or more.
-
Throw away any leftover Primer G.
-
Do not apply too much Primer G.
(b) Install new windshield moulding outer upper before the adhesive dries.
NOTE: Do not drive the vehicle for the amount of time written in the table below.
Minimum time:
7. CHECK FOR LEAKS AND REPAIR
(a) Conduct a leak test after the adhesive has completely hardened.
(b) Seal any leaks with auto glass sealer.
