Supra L6-2997cc 3.0L DOHC MFI (1998)
Brake Pad: Service and Repair
Front
REPLACEMENT
1. Remove front wheel.
Remove the wheel and temporarily fasten the disc with the hub nuts.
2. Inspect pad lining thickness.
Check the pad thickness through the caliper inspection hole and replace the pads if they are not within the specification.
Minimum thickness: 1.0 mm (0.039 inch)
3. Lift up caliper.
a. Hold the sliding pin on the bottom and loosen the installation bolt.
b. Remove the installation bolt.
c. Lift up the caliper and suspend it securely.
HINT: Do not disconnect the flexible hose from the caliper.
