Supra L6-2997cc 3.0L DOHC MFI (1998)
a. Using a press, press out the bearing.
b. Using a snap ring expander, remove the snap ring from the vane pump shaft.
NOTICE: Be careful not damage the vane pump shaft.
c. Using a snap ring expander, install a new snap ring.
NOTICE: Be careful not damage the vane pump shaft.
d. Coat a new bearing with power steering fluid.
e. Using a press, press in the bearing.
REASSEMBLY
NOTICE: When using a vise, do not overtighten it.
1. Coat with power steering fluid.
2. Install vane pump shaft with bearing.
a. Wind vinyl tape on the serrated part of the shaft.
b. Using SST 09608-04031 or equivalent, press in the shaft with the bearing to the front housing.
NOTICE: Be careful not to damage the oil seal.
c. Using snap ring pliers, install a new snap ring to the front housing.
3. Install straight pins.
Using a plastic hammer, drive in two new straight pins to the front housing.
4. Install cam ring.
Align the holes of the ring and straight pins, and install the ring with the inscribed mark facing outward.