Supra L6-2997cc 3.0L DOHC MFI (1998)
Valve Body: Service and Repair
Removal and Replacement Procedures
VALVE BODY ASSEMBLY
ON-VEHICLE REPAIR
CAUTION: When working with Formed In Place Gasket (FIPG) material, you must observe the following items.
^
Using a razor blade and gasket scraper, remove all the old FIPG material from the gasket surfaces.
^
Thoroughly clean all components to remove all the loose material.
^
Clean both sealing surfaces with a non-residue solvent.
^
Apply FIPG in an approximately 1 mm (0.04 inch) wide bead along the sealing surface.
^
Parts must be assembled within 10 minutes of application. Otherwise, the FIPG material must be removed and reapplied.
1. REMOVE DRAIN PLUG AND DRAIN ATF
2. REMOVE OIL PAN
NOTICE: Some fluid will remain in the oil pan.
a. Remove the 19 bolts.
b. Install the blade of Special Service Tool (SST) between the transmission case and oil pan, cut off applied sealer, and remove the oil pan.
SST 09032-00100
NOTICE: When removing the oil pan, be careful not to damage the oil pan flange.
3. REMOVE 3 MAGNETS FROM OIL PAN
