Supra L6-2997cc 3.0L DOHC MFI (1998)
HINT: Use the adjusting washers which were removed.
(f) Align the matchmarks and install the propeller shaft on the differential with the 3 bolts, washers and nuts.
NOTICE: Bolts should be inserted from the propeller shaft side.
Torque: 79 N.m (805 kgf.cm, 58 ft.lbf)
(g) If using a new propeller shaft.
(1) w/ Phasemarks:
Install the propeller shaft phasemarks and differential phasemarks so the their respective alignment phasemarks match.
If the propeller shaft phasemarks and differential phasemarks do not align, install the propeller shaft and differential alignment phasemarks
as close together as possible.
(2) w/o Phasemarks:
Install the propeller shaft.
Torque: 79 N.m (805 kgf.cm, 58 ft.lbf)
(h) Torque the 2 center support bearing set bolts.
Torque: 49 N.m (500 kgf.cm, 36 ft.lbf)
HINT: Adjust the center support bearing to keep the dimension, as shown with the vehicle in the unladen condition.
Under the same condition, check if the center line of the center support bearing is at right angles to the shaft axial direction.
(i) Using SST, torque the adjust nut. SST 09922-10010
Torque: 50 N.m (515 kgf.cm, 37 ft.lbf)
HINT: Use torque wrench with a fulcrum length of 34.5 cm (13.6 in.).
3. ADJUST PROPELLER SHAFT JOINT ANGEL