Supra L6-3.0L DOHC (7M-GE) (1990)
Maximum inside diameter: 27.11 mm (1.0673 in.)
If the inside diameter is greater than the maximum, replace the clutch drum.
4. CHECK OVERDRIVE PLANETARY GEAR BUSHING
Using a dial indicator, measure the inside diameter of the planetary gear bushing.
Maximum inside diameter: 11.27 mm (0.4437 in.)
If the inside diameter is greater than the maximum, replace the planetary gear.
5. MEASURE PLANETARY PINION GEAR THRUST CLEARANCE
Using a feeler gauge, measure the planetary pinion gear thrust clearance.
Standard clearance: 0.20 - 0.60 mm (0.0079 - 0.0236 in.)
Maximum clearance: 1.00 mm (0.0394 in.)
If the clearance is greater than the maximum, replace the planetary gear assembly.
ASSEMBLY OF OVERDRIVE PLANETARY GEAR, OVERDRIVE DIRECT CLUTCH AND OVERDRIVE ONE-WAY CLUTCH
1. INSTALL THRUST WASHER TO OVERDRIVE PLANETARY GEAR
Install the thrust washer to the overdrive planetary gear, the grooved side facing upward.
2. INSTALL OVERDRIVE ONE-WAY CLUTCH