Supra Sport Roof L6-2997cc 3.0L DOHC MFI (1998)
Spark Plug: Testing and Inspection
INSPECTION
INSPECT SPARK PLUGS
NOTICE:
-
Never use a wire brush for cleaning.
-
Never attempt to adjust the electrode gap on used a spark plug.
-
Spark plugs should be replaced every 100,000 km (60,000 miles).
(a) Remove the ignition coils and high-tension cord set assembly.
(b) Inspect the electrode.
Using a megger (insulation resistance meter), measure the insulation resistance.
Standard correct insulation resistance: 10 M ohms or more
If the resistance is less than specified, proceed to step (d).
HINT: If a megger is not available, the following simple method of inspection provides fairly accurate results.
Simple Method:
-
Quickly race the engine 5 times to 4,000 rpm.
-
Remove the spark plug. (See step c)
-
Visually check the spark plug. If the electrode is dry..OK If the electrode is wet... Proceed to step
-
Reinstall the spark plug. (See step g)
(c) Using a 16 mm plug wrench, remove the 6 spark plugs.
(d) Visually check the spark plug for thread damage and insulator damage.
If abnormal, replace the spark plug.