Supra Sport Roof L6-2997cc 3.0L DOHC MFI (1998)
-
Left and right washers should be the same thickness.
-
This shim is installed on top of the upper mount stopper and it used for adjustment.
3. HOW TO READ THIS CHART
Take measurements, then calculate the No.2 and No.3 joint angle.
Make the calculated values on the chart and read the coordinates.
Replace the adjusting washer and shim in accordance with the coordinates read and adjust the joint angles.
Example
Measurements (Installation angle):
Intermediate shaft: 1°50'
Propeller shaft: 2°14'
Differential: 2°15'
Joint angle:
No.2: 1°50' - 2°14' = -24'
No.3: 2°14' - 2°15' = -1'
Adjustment:
Center support bearing
Standard parts: 4 mm - 2 mm = 2 mm
Use adjusting washers which are 2 mm (0.079 in.) thicker.
Differential
Use adjusting shims which are 1.6 mm (0.063 in.) thicker.
HINT:
-
Maintain the same thickness for the adjusting washers and adjusting shims on both the left and right sides.
-
If a washer and shim of the exact thickness are not available, use the parts which are the nearest in thickness.