toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Flex Plate > < Drivetrain - Drive/Axle Shaft Replacement Precautions|Page 5185
Page 14
background image

NOTICE:  The joint angle should be checked when the propeller shaft is removed and installed.

4. NORMAL ROOF:

INSTALL CENTER FLOOR CROSSMEMBER BRACE
Install the center floor crossmember brace and 4 bolts.

Torque: 13 N.m (130 kgf.cm, 9 ft.lbf) 

5. SPORT ROOF:

INSTALL CENTER FLOOR CROSSMEMBER BRACE
Install the center floor crossmember brace and 6 bolts.

Torque: 13 N.m (130 kgf.cm, 9 ft.lbf) 

6. INSTALL HEAT INSULATOR

Install the heat insulator and torque the 4 nuts.

Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf) 

7. INSTALL EXHAUST PIPE

 

Flex Plate > < Drivetrain - Drive/Axle Shaft Replacement Precautions|Page 5185