T100 Extra Cab Pickup 4WD V6-3.4L (5VZ-FE) (1997)
c. Using a pin punch, tap in the slotted spring pin.
4. Install parking lock cable assembly, as follows:
a. Apply Multi-Purpose (MP) grease to the inside sliding surface of the control shaft support sub-assembly.
b. Install the parking lock cable sub-assembly to the control shaft support sub-assembly, as shown.
c. Tighten the casing cap.
Torque: 50 N.m (37 ft. lbs.).
5. Check parking lock cable operation, as follows:
a. push the parking lock cable to check that there is no scraping noise and stopper knocking due to lack of grease.
b. Put the select lever in P position and check that the lever is locked when you push the parking lock cable 7 mm (0.28 inch).
c. Check that the select lever is released when the parking lock cable is free.
d. Measure the freeplay of the tip of the control lever when the control shaft is play.
Freeplay: 6 mm (0.24 inch).
e. Release the select lock and measure the freeplay of the tip of the control lever when the shift lock plate and stopper lock in the shift direction.
Freeplay: 10 mm (0.39 inch).
f.
Put the select in Park (P) position and check that the shift lock plate does not contact the stopper when the control shaft is rotated towards R
position.
g. With the stopper in operation, release shift lock an: check that shifting from P to R position is prevented when selecting a position.
h. For each shift position from R to L position, check that the ignition key plate turning from ACC position to LOCK position is prevented.
6. Install three clamps.