T100 Extra Cab Pickup 4WD V6-3.4L (5VZ-FE) (1997)
Drive/Propeller Shaft: Service and Repair
Overhaul
DISASSEMBLY
Front:
1. Remove sleeve yoke from front propeller shaft, as follows:
a. Place matchmarks on the sleeve yoke and propeller shaft.
b. Pull out the sleeve yoke from the propeller shaft.
Rear:
1. Separate propeller shaft and intermediate shaft, as follows:
a. Place the matchmarks on the flanges.
b. Remove four nuts, bolts and washers.
2. Remove center support bearing from intermediate shaft, as follows:
a. Using a hammer and chisel, loosen the staked part of the nut.
b. Using Special Service Tool (SST) 09330-00021 or equivalent, to hold the flange, remove the nut.
c. Place matchmarks on the flange and shaft.
d. Using SST 09950-30010 (09951-03010, 09953-03010, 09954-03010, 09955-03030, 09956-03020) or equivalents, remove the flange from the
intermediate shaft.
e. Remove the center support bearing from the intermediate shaft.
ASSEMBLY