T100 Extra Cab Pickup 4WD V6-3.4L (5VZ-FE) (1997)
6. Disconnect brake line and parking brake cable. Using Special Service Tool (SST) 09751 - 36011 or equivalent, disconnect the brake line from the
wheel cylinder.
Torque: 15 Nm (11 ft. lbs.).
7. Remove rear axle shaft assembly, as follows:
a. Remove the four backing plate mounting nuts.
Torque: 69 Nm (51 ft. lbs.).
b. Pull out the rear axle shaft assembly from the rear axle housing.
NOTE: Be careful not to damage the oil seal.
8. Remove O-ring from rear axle housing.
INSTALLATION
Installation is in the reverse order of removal.
NOTE: After installation, check the ABS speed sensor signal.
Inspection and Repair
Rear Axle Shaft - 4 WD ( 1 Of 2)