T100 Pickup 2WD L4-164.4 2693cc 2.7L DOHC (3RZ-FE) (1995)
Alarm Module: Technical Service Bulletins
Antitheft - TVSS Installation Supplment
REF.: ACCESSORIES
NO.: AX95-OO1
DATE: JANUARY 27, 1995
MODEL: VD (T1OO EXTRA CAB)
T100 EXTRA CAB TVSS INSTALLATION SUPPLEMENT
When installing the TVSS system on the new T100 Extra Cab Vehicles, the ECU should be mounted under the driver's side rear seat cushion. Please use
the following supplemental installation instructions to complete the TVSS installation:
MOUNTING THE TVSS ECU
STEP ONE
1)
Pull up the driver's side rear seat cushion.
2)
Carefully pull the carpet back, exposing the storage cover.
3)
Remove the storage cover, as shown in "Figure A".
STEP TWO
1)
Cover the edge of the opening in the metal storage compartment with foam tape, as shown in "Figure B".
2)
Route the 26P TVSS ECU Connector behind the seat belt anchor and through the opening into the metal storage compartment.
STEP THREE
1)
Measure and mark the ECU mounting location on the floor board of the vehicle (inside the metal storage compartment). Be certain that the spare
tire jack does not interfere with the ECU.
NOTE: