T100 Pickup 2WD L4-2.7L (3RZ-FE) (1994)
^
Type "A": Has a projection on the upper and lower side of the brake pad. (See illustration.)
^
Type "B": Has a flat upper and lower edge on the brake pad backing plate.
Type "A" Brake Pad
A.
Remove the anti-squeal spring, clip and pad guide pin.
B.
Remove the brake pads with the anti-squeal shims.
C.
Clean any dust from the brake pads.
D.
Apply a small amount of the disc brake caliper grease (1-2 mm thick) to the areas indicated in the illustration.
NOTE:
Do NOT apply grease to the friction surfaces of the brake pads or the disc rotor.
E.
Install the brake pads with the anti-squeal shims.
NOTE:
Clean excess grease from the brake pads and caliper.
F.
Install the pad guide pin, clip and anti-squeal spring.
G.
Install the wheel assembly.