T100 Pickup 2WD V6-3.4L (5VZ-FE) (1996)
Oil Pressure Gauge: Testing and Inspection
OIL PRESSURE GAUGE INSPECTION
1. INSPECT RECEIVER GAUGE OPERATION
(a) Disconnect the connector from the sender gauge.
(b) Turn the ignition switch ON. check that the receiver gauge needle indicates LOW.
(c) Ground terminal on the wire harness side connector through a 3.4 W test bulb.
(d) Turn the ignition ON, check that the bulb lights up and the receiver gauge needle moves to the high side.
If resistance value is not as specified, replace the receiver gauge.
2. INSPECT RECEIVER GAUGE RESISTANCE
Measure the resistance between terminals A and B.
Resistance: Approx. 25.0 Ohms
If resistance value is not as specified, replace receiver gauge.