T100 Pickup 2WD V6-3.4L (5VZ-FE) (1996)
Fuel Pressure Control Solenoid: Testing and Inspection
1. REMOVE VSV ASSEMBLY.
-
w/ EGR:
Disconnect the 2 connectors and 4 vacuum hoses, and remove the 2 bolts and VSV assembly.
-
w/o EGR:
Disconnect the connector and 2 vacuum hoses, and remove the 2 bolts and VSV assembly.
3. INSPECT VSV.
A. Inspect VSV for open circuit.
-
Using an ohmmeter, check that there is continuity between the terminals.
Resistance: At 20°C (68°F) 33 - 39 ohms
-
If there is no continuity, replace the VSV.
B. Inspect VSV for ground.
-
Using an ohmmeter, check that there is no continuity between each terminal and the body.
-
If there is continuity, replace the VSV.
C. Inspect VSV operation.