T100 Pickup 2WD V6-3.4L (5VZ-FE) (1996)
Before installation of the fluorocarbon resin tape, it is necessary to pre-release the colored film about 5 mm for each side. (Not fully released.)
B.
By pulling up the seat belt, put the fluorocarbon resin tape through the hole of the shoulder belt anchor. Match the shoulder belt anchor to
the center of the tape.
C.
Remove the upper side colored film from the fluorocarbon resin tape, and securely affix the tape to the outside of the shoulder belt anchor.
D.
Remove the lower side colored film from the fluorocarbon resin tape, and securely affix the tape to the outside of the shoulder belt anchor.
NOTE:
^
Be sure to affix the fluorocarbon tape securely along all edges.
^
Pay attention not to make any wrinkles or slack in the fluorocarbon resin tape.
E.
Remove the clip.
F.
By pulling the seat belt up and down several times, as shown in the illustration, securely affix the fluorocarbon resin tape and confirm the
smoothness of the belt movement.