T100 Pickup 2WD V6-3.4L (5VZ-FE) (1996)
5. Coat inside of the hub and cap with MP grease.
6. Install the inner bearing and the oil seal, as follows:
a. Place bearing into the hub.
b. Using Special Service Tool (SST) 09950 - 60020 (09951 - 00710), 09950 - 70010 (09951 - 00150) or equivalents, and a hammer, install the
oil seal into the hub.
NOTE: Be careful not to damage the Anti-Lock Brake System (ABS) speed sensor rotor.
c. Coat the oil seal lip with MP grease.
7. Install the axle hub with the disc, as follows:
a. Place the axle hub on the spindle.
b. Install the bearing and thrust washer.
8. Adjust the preload, as follows:
a. Install and torque the nut.
Torque: 35 Nm (26 ft. lbs.).
b. Snug down the bearing by turning the hub several times.
c. Loosen the nut until it can be turned by hand.
d. Using a spring tension gauge, measure and make a note of the frictional force of the oil seal.
Preload (at starting): 4.0 N (0.9 lbs.) or less.
NOTE: Make sure to check preload in the direction of rotation.