T100 Pickup 4WD V6-180.5 2959cc 3.0L SOHC (3VZ-E) (1993)
/Page-688001.png)
Throttle Position Sensor: Adjustments
ADJUSTMENT
1. Loosen the two set screws that secure the Throttle Position Sensor (TPS) to the throttle housing. (DO NOT REMOVE THE SCREWS).
2. Disconnect the connector to the TPS and connect an Ohmmeter to terminals IDL and E2.
3. Insert a 0.62mm (0.024in) feeler gauge between the throttle stop screw and stop lever.
4. Rotate the TPS counter-clockwise and slowly back clockwise until the Ohmmeter just looses continuity, (infinite ohms).
5. Secure the TPS with the two set screws.
6. Remove the feeler gauge and recheck TPS setting.
^
There should be continuity with a 0.50mm (0.020in) feeler gauge inserted in the stop.
^
There should be NO continuity with a 0.77mm (0.030in) feeler gauge inserted in the stop.
7. Remove the Ohmmeter and reconnect the TPS connector.
