T100 Regular Cab Pickup 2WD L4-2693cc 2.7L DOHC MFI (1998)
Using a dial indicator, measure the disc runout 10 mm (0.39 inch) from the outside edge of the disc.
Maximum disc runout: 0.07 mm (0.0028 inch)
If the runout is greater than the maximum, replace the disc or grind it on a "On-Car" brake lathe.
HINT: Before measuring the runout, check that the front hub bearing play is within specification.
6. Install 4 pad support plates.
7. Install new pads.
NOTICE: When replacing worn pads, the anti-squeal shims and wear indicator plates must be replaced together with the pads.
a. Install a pad wear indicator plate to the pad.
b. 1 ton: Install the anti-squeal shim to each pad.
c. 0.5 ton: Install the 4 anti-squeal shims to each pad.