T100 Regular Cab Pickup 2WD L4-2693cc 2.7L DOHC MFI (1998)
Ignition Cable: Testing and Inspection
INSPECTION
INSPECT HIGH-TENSION CORDS
(a) Remove the air cleaner cap and MAF meter assembly.
(b) Remove the intake air connector.
(c) Disconnect the high-tension cords from the spark plugs.
NOTICE: Pulling on or bending the cords may damage the conductor inside.
(d) Disconnect the high-tension cords from the ignition coils.
(1) Using a screwdriver, lift up the lock claw and disconnect the holder from the ignition coils.
(2) Disconnect the high-tension cord at the grommet.
NOTICE:
-
Pulling on or bending the cords may damage the conductor inside.
-
Do not wipe any of the oil from the grommet after the high- ~ tension cord is disconnected.
(e) Using an ohmmeter, measure the resistance. Maximum resistance: 25 K ohms per cord