T100 Regular Cab Pickup 2WD L4-2693cc 2.7L DOHC MFI (1998)
Impact Sensor: Service and Repair
REMOVAL
NOTICE:
^
If the wiring connector of the SRS is disconnected with the ignition switch at ON or ACC position, DTCs will be recorded.
^
Never use SRS parts from another vehicle. When replacing parts, replace them with new ones.
^
Never reuse the sensor involved in a collision when the SRS has been deployed.
^
Never repair a sensor in order to reuse it.
1. REMOVE THESE PARTS
a. Battery
b. Air cleaner assembly
2. REMOVE FRONT AIRBAG SENSOR
a. Disconnect the connector.
b. Using a torx wrench, loosen the 2 screws and the sensor.
Torx wrench: T40 (Part No. 09042-00020 or locally manufactured tool).
INSTALLATION
1. INSTALL FRONT AIRBAG SENSOR
a.Install the sensor so that the arrow on the sensor faces toward the front of the vehicle.
b. Using a torx wrench, install the sensor with 2 screws.
Torx wrench: T40 (Part No. 09042-00020 or locally manufactured tool)
Torque: 29 N.m (300 kgf.cm, 22 ft.lbf)
c. Connect the connector.
NOTICE:
^
Make sure the sensor is installed to the specified torque.
^
If the sensor has been dropped, or there are cracks, dents or other defects in the case, brackets or connector, replace the removed sensor,
always replace the set bolts with new ones.
^
The sensor set bolts which have been anti-rust treated. When the sensor is removed, always replace the set bolts with new ones.
^
After installation, shake the sensor to check that there is no looseness.
^
The front sensor is equipped with an electrical connection check mechanism. Be sure to lock this mechanism securely when connecting the
connector . If the connector is not securely locked, a malfunction code will be detected by the diagnostic system.
2. INSTALL REMOVED PARTS