T100 Regular Cab Pickup 2WD L4-2693cc 2.7L DOHC MFI (1998)
Starter Motor: Testing and Inspection
INSPECTION
INSPECT COMMUTATOR FOR OPEN CIRCUIT
Using an ohmmeter, check that there is continuity between the segments of the commutator.
If there is no continuity between any segment, replace the armature.
INSPECT COMMUTATOR FOR GROUNDED
Using an ohmmeter, check that there is no continuity between the commutator and armature coil core.
If there is continuity, replace the armature.
INSPECT COMMUTATOR FOR DIRTY AND BURNT SURFACES
If the surface is dirty or burnt, clean it with sandpaper (No.400) or on a lathe.
INSPECT COMMUTATOR CIRCLE RUNOUT
a. Place the commutator on V-Blocks.
b. Using a dial indicator, measure the circle runout.
Maximum circle runout: 0.05 mm (0.0020 in.)
If the circle runout is greater than maximum, correct it on a lathe.
INSPECT COMMUTATOR DIAMETER