T100 Regular Cab Pickup 2WD L4-2693cc 2.7L DOHC MFI (1998)
Terminal 30:
1. Insulation paper
2. Terminal insulator (inside)
NOTE: Be careful to install the terminal Insulator in the correct direction.
3. Contact plate
4. Terminal bolt
5. O-ring
6. Packing and terminal insulator (outside) Install the packing to the terminal insulator, and install them.
HINT: Match the protrusion of the insulator with the indentation of the housing.
7. Wave washer
8. Terminal nut
Terminal C:
1. Terminal insulator (inside)
2. Contact plate
3. Terminal bolt
4. O-ring
5. Terminal insulator (outside)
6. Wave washer
7. Terminal nut
NOTE: Be careful to install the terminal insulator (inside) in the correct direction.
b. Temporarily tighten the terminal nuts.
5. TIGHTEN TERMINAL NUT
a. Put a wooden block on the contact plate and press it down with a hand press.
Dimensions of wooden block: 20 x 37 x 40 mm (0.79 x 1.46 x 1.57 in.)
Press force: 981 N (100 kgf, 221 lbf)